| Subject | Text |
| Thanks Phils and minnie.
I just found what the problem is. It's a 47uF/35V filter capacitor for |
| AT49F002T-50TC data | [b:0e0ec7fbac]Features[/b:0e0ec7fbac]
• Single-voltage Operation
– 5V Read
– 5V Reprogramming
• |
|
|
| PHILLIPS TV SPEAKERS | HELLO, To begin with the addition of speakers to a unit has to involve the understanding of the tot |
| Taking apart my Philips DECT 2111S/11 | Hi,
I am trying to take apart my Philips DECT 211 phone, because the speaker has managed to come |
| Car amp AudioSystem M-80.4 Service Manual | Hi all,
I need a schematice diagram or Service Manual car amplifier AudioSystem M-80.4 for repair |
| Re: Light leakage | Can't hurt anything to try manually degaussing set.
I seem to recall a Philips set that had a bad v |
| As you may be aware, Bose has made many versions of the lifestyle series.
Some of which may be sim |
| Sony Amp - The woes continue | Andreas,
Try removing every input and output and see what happens, then add them back one by one |
| str-de945 problem | Is the action (or lack thereof) intermittant? If so, it is likely a bad solder joint. The IR sensors |
| SONY STR KSL5 Protect Fault | I have a SONY STR KSL5 home cinema system which after about 5 mins shuts off with the word "PROTECT" |
| Oh..
.. ok thank you, Mel.
The only flat faced crt's were Sony Trinitrons when I was an active |
| Samsung CB21H1T,S15a | I have a problem with TV Samsung cb 21h1t,power is dead,voltage 300v is present,but stand by is not |
| Samsung 191t power problem | The Unit will power up but intermittently the unit will power cycle. this appears to happen only wh |
| Here's the parts that I used:
[url=R509 100K Ohm 1W resistor[/url] - got an set on Amazon. I prob |
| yeah! tv still working but, always need to push the reset button in front. otherwise no signal with |
| repairing an old sansui amplifier | hello every one ,
new member here and also newby in the electronic repair
i have an old sansui |
| TV Samsung CXA1316B | Anybody who has service manual or schematic of TV Samsung model CXA1316B or similar models.Thanks |
|
|
| Transistor question if you know electronics please help! | I need to replace a couple transistors and I have the numbers but don't know where to purchase them |
| building a generator | how do I use a standard 240v single phase ac motor driven by a petrol engine to create 240vac betwee |
| Ok made the check. At first I was not sure I could call up the counter. Not sure how I did it but no |
| Dead Black Diamond BD28WS | Hello to everyone this is my first post here. I have a BD28WS Black Diamond TV. The fault is when I |
| Looking for Pioneer VSX-D307 Receiver Service Manual | I'm looking for a service manual (or at least a schematic) for my Pioneer VSX-D307 Receiver.
Anyo |
| voltage for relay | hi,i have a problem on my yamaha rx-v392 model...i need to know what is the voltage of the relay in |
| need help designing a circuit. | hello all... I'm working on an art project... and I need help designing an electrical circuit. What |
| Can't remember. Isn't it in Admin tools, domains and trusts or something?
Do you have Active Direct |
| thank you for your replies
the original power supply died some years ago, and i have bought a 1000m |
| H/K AVR 25II - protect mode only with center channel | Hi,
First thanks for the tech manual/schematics! Wonderful start. I can sort of read schematics a |
| Re: Onkyo TX-SV535 Amp / Remote Speakers NOT Working | [quote:586d3411be="kayecross"]I can not get the remote speaker button to work on my amp. I have inst |
| Hi again,
By bypassing the main speaker relay everything works great. Does anyone know if this mi |
| avr 130 one of the surround outputs is very very low | got a harman kardon avr 130 one of the surround outputs is very very low
when i connected speaker t |